Take this example. A consignor books a container of lithium ion batteries, UN 3480. The forwarder comes back with a message from the carrier’s dangerous goods desk: the test summary cites the Manual of Tests and Criteria, Revision 6, Amendment 1, the Manual is now at Revision 8, Amendment 1, please send a new test summary. The edition is the only reason given.
Does the test summary have to be revised every time the Manual is revised?
No. UN Model Regulations 2.9.4(a), repeated in IMDG Code 2.9.4.1, allows cells and batteries made to a type that met sub-section 38.3 of the Manual, Revision 3, Amendment 1, or any later revision and amendment applicable on the date of type testing, to continue to be transported.
The summary also cannot simply be reissued with a newer edition on it. It has to state the revised edition and amendments used for the tests. A summary citing Revision 8 is correct only if the type was tested to Revision 8.
Where the rule sits in each regulation
| Subject | UN Model Regulations | IMDG Code 42-24 | 49 CFR |
|---|---|---|---|
| Type tested under an earlier revision may continue to be transported | 2.9.4(a) | 2.9.4.1 | 173.185(a)(1)(i) |
| Types tested only to Revision 3 (without Amendment 1) no longer valid | 2.9.4(a) | 2.9.4.1 | 173.185(a)(1)(ii) |
| Test summary to be made available | 2.9.4(g) | 2.9.4.7 | 173.185(a)(3) |
| What makes a new type | Manual of Tests and Criteria, Part III, 38.3.2.2 | ||
The cut-off is Revision 3, Amendment 1. A type tested only to the original Revision 3 has lost its validity, with one saving: cells and batteries manufactured to such a type before 1 July 2003 may still be transported if every other applicable requirement is met.
A test summary citing an earlier revision
Neither the age of the report nor the edition number on it is a defect. PHMSA says the same of the test summary in its published guidance (Q7): a summary does not expire, and a new one is needed only where a different design has had to be retested. A summary with a required element missing or wrong still has to be corrected, even though the underlying test remains valid.
Three facts decide whether the report still supports the shipment:
- The date on which the type was tested.
- The revision and amendment of the Manual applicable on that date.
- Whether the cells or batteries now offered are still the tested type.
Under 2.9.4.1 of the IMDG Code and 173.185(a)(1) of 49 CFR, a change of edition alone does not trigger retesting or the reissue of a test summary. A carrier may have a separate booking condition of its own. The consignor should answer the DG desk with the paragraph reference and ask whether such a condition exists before paying a laboratory for tests the regulations do not ask for.
Design changes that do require testing
Paragraph 38.3.2.2 of the Manual treats a cell or battery as a new type, to be put through the required tests, when it differs from the tested type by:
- for primary cells and batteries, a change of more than 0.1 g or 20% by mass, whichever is greater, to the cathode, the anode or the electrolyte;
- for rechargeable cells and batteries, a change in nominal energy of more than 20%, or an increase in nominal voltage of more than 20%;
- a change that might lead to failure of any of the tests. Revision 8, Amendment 1 replaced “would” with “might” in this item.
The Note under that paragraph lists changes that may fall under the third item: a different material for the anode, cathode, separator or electrolyte; a change to protective devices, including hardware and software; a change to the safety design of the cell, such as the venting valve; a change in the number of component cells; and a change in the way the component cells are connected. Amendment 1 adds certain repair, refurbishment and remanufacturing to these examples.
For sea transport the amended text is the one to read. The December 2025 errata and corrigenda to IMDG Code Amendment 42-24 change the definition of “Manual of Tests and Criteria” to the eighth revised edition, ST/SG/AC.10/11/Rev.8/Amend.1.
Three changes, applied to the criteria:
- A 4S2P pack becomes 4S3P with identical cells. Nominal voltage is unchanged and nominal energy rises by 50%. That exceeds the 20% limit for rechargeable batteries, and the number of component cells has changed. It is a new type and has to be tested.
- The pack maker switches to a second-source cell. The answer depends on the cell. A different cathode, anode, separator or electrolyte material, or a different venting design, falls within the Note’s examples.
- The battery management system gets a firmware update. Software is part of the protective devices named in the Note. Whether the update might lead to a test failure depends on what it changes, the overcharge protection relied on in test T.7 being the obvious case.
What the shipper checks on the test summary
The test summary described in 38.3.5 of the Manual has to state which revised edition of the Manual was used and which amendments, if any. That line, with the model number and the test report reference, is what the shipper has to work with.
- Confirm that the summary covers the battery offered. For the UN 3480 shipment in the example, that is the battery’s own model or part number, not a similar model in the same product family. Where the summary was prepared for equipment containing a battery, the equipment model number is also an accepted identifier.
- Read the edition line against the test date. The edition named should be Revision 3, Amendment 1 or a later revision and amendment that applied when the type was tested. A summary that names no edition goes back to the manufacturer for correction.
- Where coverage is unclear, for instance after a product refresh under the same model name, ask the manufacturer to confirm that the current configuration conforms to the tested type.
The manufacture dates that trigger the test summary differ between the texts. Under the UN Model Regulations and the IMDG Code, it applies to cells and batteries manufactured after 30 June 2003. Under 49 CFR 173.185(a)(3), it applies to those manufactured on or after 1 January 2008. All three texts except button cells installed in equipment, including circuit boards.
- UN Model Regulations, Rev. 24, Volume I — 2.9.4
- UN Manual of Tests and Criteria, Rev. 8 (2023) and Amendment 1 (2025) — Part III, 38.3.2.2 and 38.3.5
- IMO — IMDG Code Amendment 42-24, Errata and corrigenda, December 2025
- 49 CFR 173.185 — Lithium cells and batteries (eCFR)
- PHMSA — Lithium Battery Test Summary guidance (2024)

